Assembling
We are increasingly noticing the desire of our customers for ready-to-install parts. Bechtold has made the way from a component supplier to a systems supplier.
We organise add-on parts (e.g. turned and milled parts), special packaging, additional parts and, if necessary, also perform the assembly. All necessary documents and certificates are created by us.
We are responsible for the functionality of assemblies, pay attention to completeness and carry out interdisciplinary work. It is very important to us that all desired back-work is done. Even if our customer does not get to see the assemblies at the end, he can be sure that all products, that are sent on his behalf, are checked and in order.
Product examples
Decorative ceiling lamp
DESCRIPTION
Design lamp in a mix of materials.
MATERIAL
steel painted, stainless steel electropolished
Housing for compressed air service unit
DESCRIPTION
Housing for indoor installation, completely redesigned without welding.
MATERIAL
stainless steel (1.4301 1,5/2/4 mm)
Retainer
DESCRIPTION
Ready-to-install part for spotlights, assembled and packaged.
MATERIAL
aluminium and purchased parts
Motor compressor casing
MATERIAL
stainless steel, plastic-coated, welded according to EN 15085
Housing for railway technology, brake system for trains
DESCRIPTION
Container on the outside of a train, welded according to EN15085, surface according to DB standard, powder coating and galvanisation, ready for installation with insulation.
MATERIAL
steel, stainless steel, aluminium
Part for car interior (carrier part)
DESCRIPTION
Pre-assembled unit for automotive interiors in lot sizes < 250 pieces, riveted and tested.
MATERIAL
sheet steel, galvanised
Protective housing
DESCRIPTION
Ready-to-install housing made of pickled stainless steel and aluminium with hardcoat.
MATERIAL
stainless steel and aluminium
Custom-made control panel for ship
DESCRIPTION
Single-unit production for a ship command bridge in aluminium, non-magnetic. All necessary add-on parts included.
MATERIAL
aluminium
Support frame for railway technology
DESCRIPTION
Complete support frame, welded according to EN15085, multi-layer coating and pre-assembly.
MATERIAL
steel (S355 J2+N)
Electronic part
DESCRIPTION
Mounting part in an electronic system, with self-clinching studs (pems).
MATERIAL
aluminium (AlMg3, black anodized)
Electronic housing
DESCRIPTION
Housing for a radio set.
MATERIAL
aluminium (AlMg3)
